LEMON Manuals: Even more car manuals for everyone

Gear Selector, Internal

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Gear Selector Assembly
GLL151625Courtesy of VOLVO CARS OF NORTH AMERICA.
Position Component Position Component
1 Complete control unit 10 Spring
2 Ball limiter, 5-6 control 11 Lever for lengthwise movement
3 Gearshift gate 12 Spring
4 Back-up (reversing) lamps switch 13 Lever for lateral movement
5 Flange 14 Catch plate
6 Gearshift gate pin 15 Carrier plate
7 Lower gear selector 16 Bleed cap
8 Gear selector rod 17 Ball limiter for gear selector
9 Upper gear selector    

The gear selector is in a single complete unit with the exception of the ball limiter for the gear position. This is threaded in the transmission housing. The gear selector is held in position by 4 screws. 2 guide pins in the control housing and a needle bearing in the bottom of the gear selector unit control the position in the transmission housing.

Back-up (reverse) gear in the gear selector assembly is furthest to the right and down. Neutral is between 3rd and 4th.

The back-up (reversing) lamp switch is in the control housing and is affected by the shaft for lateral movement. The back-up (reversing) lamp switch is directly connected to the central electronic module (CEM).

The gear selector unit must not be dismantled. In the event of a fault the whole gear selector unit must be replaced.

4 gear selector forks transfer the movement from the control to the relevant coupling sleeve.