LEMON Manuals: Even more car manuals for everyone

Adjustment [08/2020 - 12/2021]: Procedure

  1. INSPECT TIRES 

    Refer to INSPECTION [08/2020 - ]

  2. MEASURE VEHICLE HEIGHT 

    Refer to ADJUSTMENT [08/2020 - 12/2021] 

  3. INSPECT CAMBER 
    NOTE:

    Inspect while the vehicle is unloaded.

    1. Install a camber-caster-kingpin gauge.
      GTY439720Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Camber-caster-kingpin Gauge
    2. Inspect the camber.

      Check the values in the top table.

      Refer to CAUTION / NOTICE / HINT 

      HINT: 

      Camber is not adjustable. If the measurement is not within the specified range, inspect the suspension parts for damage and/or wear, and replace them if necessary.

  4. INSPECT TOE-IN 
    NOTE:

    Inspect while the vehicle is unloaded.

    1. Bounce the vehicle up and down at the corners to stabilize the suspension.
    2. Release the parking brake and move the shift lever to N (for Automatic transaxle, Hybrid transaxle).
    3. Push the vehicle straight ahead approximately 5 m (16.4 ft.). (Step A)
    4. Put tread center marks on the rearmost points of the rear wheels and measure the distance between the marks (dimension B).
      GTY425632Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Tread Center Mark
      *b Dimension B
      Front of the Vehicle
    5. Slowly push the vehicle straight ahead to cause the rear wheels to rotate 180°. Use the rear tire valve as a reference point.

      HINT: 

      Do not allow the wheels to rotate more than 180°. If the wheels rotate more than 180°, perform the procedure from step A again.

    6. Measure the distance between the tread center marks on the front of the rear wheels (dimension A).

      Check the values in the top table.

      Refer to CAUTION / NOTICE / HINT 

      GTY427701Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Dimension A
      Front of the Vehicle

      HINT: 

      Measure "B - A" only when "C + D" cannot be measured.

      If the toe-in is not within the specified range, adjust it at the rear suspension toe adjust cam sub-assembly.

  5. ADJUST TOE-IN 
    1. Loosen the nut of the rear No. 2 suspension arm assembly (on the rear suspension member sub-assembly side).
      NOTE:

      Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

      GTY931821Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Rotate the rear suspension toe adjust cam sub-assembly to adjust the toe-in.

      Check the values in the top table.

      Refer to CAUTION / NOTICE / HINT 

      HINT: 

      • Rotating the rear suspension toe adjust cam sub-assembly by one notch changes the toe by approximately 2.8 mm (0.112 in.).
      • Perform adjustments so that the value is as close as possible to the median of the specified range.
      GTY483974Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Front of the Vehicle
    3. Tighten the nut of the rear No. 2 suspension arm assembly (on the rear suspension member sub-assembly side).

      Torque: 103 N.m (1050 kgf/cm, 76 ft.lbf) 

      NOTE:

      Hold the rear suspension toe adjust cam sub-assembly while rotating the nut.

  6. ELECTRONICALLY CONTROLLED BRAKE SYSTEM CALIBRATION 

    HV model: Refer to UTILITY [02/2019 - 12/2021]

    Gasoline model: Refer to UTILITY [11/2018 - ]