LEMON Manuals: Even more car manuals for everyone

No. Fast Idle/Runs On: Contents

9 FAST IDLE/RUNS ON
DESCRIPTION
  • Engine speed continues at fast idle after warm-up.
  • Engine runs after ignition is switched off.
TROUBLE AREA
  • Cooling system malfunction
  • ECM DTC is stored
  • Accelerator pedal stuck depressed
  • Erratic signal to ECM
    • APP sensor or related circuit malfunction
    • Neutral switch or related circuit malfunction (MTX)
    • Communication error between TCM and ECM (ATX)
    • A/F sensor or related circuit malfunction
    • HO2S or related circuit malfunction
    • Improper air/fuel mixture ratio control operation
  • Improper load signal input
    • Improper A/C request signal
  • Improper operation of drive-by-wire control system
  • Throttle body malfunction
  • Fuel injector malfunction
  • Spill valve control solenoid valve (built-into high pressure fuel pump) malfunction
  • Improper operation of cruise control system
  • Air leakage from intake-air system
  • Injector driver (built-into ECM) malfunction
WARNING:

The following troubleshooting flow chart contains the fuel system diagnosis and repair procedures. Read the following warnings before performing the fuel system services:

  • Fuel vapor is hazardous. It can easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel.
  • Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injury or death and damage. Fuel can also irritate skin and eyes. To prevent this, always complete "BEFORE SERVICE PRECAUTION" and "AFTER SERVICE PRECAUTION" described in this information.

    Refer to PRECAUTION [07/2015 - ]

    Refer to ON-VEHICLE INSPECTION [07/2015 - ]

NOTE:
  • Disconnecting/connecting the quick release connector without cleaning it may possibly cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting, and make sure that it is free of foreign matter.
NOTE:
  • Verify the malfunction symptom according to not only the PID value but also the symptom troubleshooting.
RELATED PIDS

Item (definition) Unit/Condition Definition Condition/Specification (Reference)
A/C Request Signal No(False)/Yes(True) A/C switch status received by ECM via CAN
  • A/C switch off: No(False)
  • A/C switch on: Yes(True)
Accelerator pedal position sensor 1 % Accelerator pedal opening angle (absolute value) input from APP sensor No. 1
  • Accelerator pedal released: Approx. 16%
  • Accelerator pedal fully depressed: Approx. 91%
V APP sensor No. 1 voltage
  • Accelerator pedal released: Approx. 0.78 V
  • Accelerator pedal fully depressed: Approx. 4.54 V
Accelerator pedal position sensor 2 % Accelerator pedal opening angle (absolute value) input from APP sensor No. 2
  • Accelerator pedal released: Approx. 7.84%
  • Accelerator pedal fully depressed: Approx. 45.49%
V APP sensor No. 2 voltage
  • Accelerator pedal released: Approx. 0.39 V
  • Accelerator pedal fully depressed: Approx. 2.27 V
Clutch Pedal Position Switch/Neutral Switch Circuit (MTX) False/True Shift lever position
  • Other than neutral: False
  • Neutral: True
Engine coolant temperature °C, °F Engine coolant temperature
  • Displays ECT
V ECT sensor No. 1 voltage Ignition switched ON (engine off)
  • ECT is 29°C {84°F}: Approx. 2.65 V
  • ECT is 88°C {190°F}: Approx. 0.71 V
Fuel pressure sensor kPa Fuel pressure
  • Displays fuel pressure
V Fuel pressure sensor voltage Ignition switched ON (engine off)
  • Fuel pressure is approx. 16.91 MPa {172.4 kgf/cm2 , 2453 psi}: Approx. 2.91 V

Idle (after warm up)
  • Fuel pressure is 3.44-3.95 MPa {35.1-40.2 kgf/cm2 , 499-572 psi}: 0.98-1.05 V (ECT is 90°C {194°F})
Engine load % Ratio of actual amount of intake air to the maximum air charging amount (mass volume) of cylinder
  • Idle (after warm up): Approx. 22.35%
  • Racing (engine speed is 2000 RPM): Approx. 17.25%
  • Racing (engine speed is 4000 RPM): Approx. 19.21%
Long term fuel trim 1 % Fuel learning correction amount estimated based on A/F sensor signal
  • Idle (after warm up): Approx. -6.25%
  • Racing (engine speed is 2000 RPM): Approx. -3.9%
  • Racing (engine speed is 4000 RPM): Approx. -3.9%
Heated Exhaust Gas Oxygen Sensor (bank 1, sensor 1) μA A/F sensor current
  • Idle (after warm up): Approx. 0-50 μA
  • Deceleration fuel cut (accelerator pedal released from engine speed of 4000 RPM or more): Approx. 3.84 mA
Heated Exhaust Gas Oxygen Sensor (bank 1, sensor 2) V HO2S voltage
  • Idle (after warm up): 0-1.0 V
  • Deceleration fuel cut (accelerator pedal released from engine speed of 4000 RPM or more): Approx. 0 V
Engine Revolutions Per Minute RPM Engine speed
  • Displays engine speed
Short term fuel trim 1 % Fuel feedback correction amount estimated based on A/F sensor signal
  • Idle (after warm up): Approx. 0%
  • Racing (engine speed is 2000 RPM): Approx. 1.56%
  • Racing (engine speed is 4000 RPM): Approx. 4.68%
Relative Throttle Position % Throttle valve opening angle (relative value) with value at throttle valve fully open timing as the start point
  • Accelerator pedal released: Approx. 12%
  • Accelerator pedal fully depressed: Approx. 82%
Vehicle Speed km/h Vehicle speed
  • Displays vehicle speed