LEMON Manuals: Even more car manuals for everyone

Battery / Charging System (Service Information): Generator: Reassembly: Procedure

  1. BRUSH ASSEMBLY NOTE 
    NOTE:

    Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat.

    GTY488053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Regulator Component
    *b Soldered Area
    1. Press the brush into the regulator component with it facing in the direction shown in the figure.
      GTY494242Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Regulator Component
      *b Brush
    2. Solder the brush to the regulator component.
  2. GENERATOR ASSEMBLY 
    1. Install the terminal B component.

      Torque: 8.5 N*m (87 kgf*cm, 6 ft.*lbf) 

      GTY494401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Rotor Component *2 Stator Coil Component
      *3 Pulley *4 Rotor
      *5 Front Bearing *6 Rear Bearing
      *7 Front Cover *8 Stator Coil
      *9 Rectifier *10 Regulator Component
      *11 Brush *12 Rear Cover
      *13 Terminal B Component - -
      N*m (kgf*cm, ft.*lbf): Specified torque - -
    2. Install the rear cover.
    3. Install the brush.

      See step  1

    4. Install the regulator component.

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    5. Install the rectifier.

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    6. Install the stator coil.

      Torque: 2.0 N*m (20 kgf*cm, 18 in.*lbf) 

    7. Install the front cover.

      Bolt 

      Torque: 4.4 N*m (45 kgf*cm, 39 in.*lbf) 

      Screw 

      Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf) 

    8. Install the rear bearing.
    9. Install the front bearing.
    10. Install the rotor.
    11. Install the pulley.

      Torque: 117.5 N*m (1198 kgf*cm, 87 ft.*lbf) 

    12. Install the stator coil component.
    13. Install the rotor component.