LEMON Manuals: Even more car manuals for everyone

Battery / Charging System (Service Information): Generator: Disassembly: Procedure

  1. BRUSH DISASSEMBLY NOTE 
    NOTE:

    Melt the solder quickly, otherwise the diodes (rectifier) and regulator will be damaged by excessive heat.

    GTY488053Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    *a Regulator Component
    *b Soldered Area
    1. Melt the solder and remove the brush from the regulator component.
  2. GENERATOR DISASSEMBLY 
    1. Remove the rotor component.
      GTY494401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Rotor Component *2 Stator Coil Component
      *3 Pulley *4 Rotor
      *5 Front Bearing *6 Rear Bearing
      *7 Front Cover *8 Stator Coil
      *9 Rectifier *10 Regulator Component
      *11 Brush *12 Rear Cover
      *13 Terminal B Component - -
      N*m (kgf*cm, ft.*lbf): Specified torque - -
    2. Remove the stator coil component.
    3. Remove the pulley.
    4. Remove the rotor.
    5. Remove the front bearing.
    6. Remove the rear bearing.
    7. Remove the front cover.
    8. Remove the stator coil.
    9. Remove the rectifier.
    10. Remove the regulator component.
    11. Remove the brush.

      See step  1

    12. Remove the rear cover.
    13. Remove the terminal B component.