LEMON Manuals: Even more car manuals for everyone

DTC Check / Clear

  1. DTC INSPECTION [NAVIGATION RECEIVER] 
    1. When using Techstream

      Body Electrical > Connectivity Master Unit > Trouble Codes 

      1. Connect the Techstream to the DLC-2.
      2. After the vehicle is identified, select the following items from the initialization screen of the Techstream.
        1. Select "Self Test".
        2. Select "All CMDTCs".
      3. Verify the DTC according to the directions on the screen.
        • If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
      4. After completion of repairs, clear all DTCs stored in the navigation receiver. (See  2 CLEARING DTC [NAVIGATION RECEIVER].)
    2. When using Diagnostic Assist Function

      DTC inspection can also be performed by launching the diagnostic assist function of the navigation receiver.

      Refer to DIAGNOSTIC ASSIST FUNCTION

  2. CLEARING DTC [NAVIGATION RECEIVER] 
    1. When using Techstream

      Body Electrical > Connectivity Master Unit > Clear DTCs 

      1. Connect the Techstream to the DLC-2.
      2. After the vehicle is identified, select the following items from the initialization screen of the Techstream.
        1. Select "Self Test".
        2. Select "All CMDTCs"
      3. Verify the DTC according to the directions on the screen.
      4. Press the clear button on the DTC screen to clear the DTC.
      5. Switch the ignition off.
      6. Switch the ignition ON (engine off or on) and wait for 5 s or more.
      7. Perform DTC inspection. (See  1 DTC INSPECTION [NAVIGATION RECEIVER].)
      8. Verify that no DTCs are displayed.
    2. When using Diagnostic Assist Function

      Clearing DTC can also be performed by launching the diagnostic assist function of the navigation receiver.

      Refer to DIAGNOSTIC ASSIST FUNCTION