DTC Check / Clear
- DTC INSPECTION [NAVIGATION RECEIVER]
- When using Techstream
Body Electrical > Connectivity Master Unit > Trouble Codes
- Connect the Techstream to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the Techstream.
- Select "Self Test".
- Select "All CMDTCs".
- Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
- After completion of repairs, clear all DTCs stored in the navigation receiver. (See 2 CLEARING DTC [NAVIGATION RECEIVER].)
- When using Diagnostic Assist Function
DTC inspection can also be performed by launching the diagnostic assist function of the navigation receiver.
Refer to DIAGNOSTIC ASSIST FUNCTION
- When using Techstream
- CLEARING DTC [NAVIGATION RECEIVER]
- When using Techstream
Body Electrical > Connectivity Master Unit > Clear DTCs
- Connect the Techstream to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the Techstream.
- Select "Self Test".
- Select "All CMDTCs"
- Verify the DTC according to the directions on the screen.
- Press the clear button on the DTC screen to clear the DTC.
- Switch the ignition off.
- Switch the ignition ON (engine off or on) and wait for 5 s or more.
- Perform DTC inspection. (See 1 DTC INSPECTION [NAVIGATION RECEIVER].)
- Verify that no DTCs are displayed.
- When using Diagnostic Assist Function
Clearing DTC can also be performed by launching the diagnostic assist function of the navigation receiver.
Refer to DIAGNOSTIC ASSIST FUNCTION
- When using Techstream