LEMON Manuals: Even more car manuals for everyone

Cruise Control Main Switch: Inspection: Procedure

  1. INSPECT CRUISE CONTROL MAIN SWITCH 
    WARNING:

    Handling the steering pad improperly can accidentally deploy the steering pad, which may seriously injure you. Read the airbag system precaution before handling the steering pad.

    Refer to PRECAUTION

    1. Disconnect the negative battery cable and wait for 1 min or more.

      Refer to REMOVAL

    2. Remove the steering pad.

      Refer to REMOVAL

      Refer to INSTALLATION

    3. Disconnect the spiral cable connector (part wiring harness-side).
    4. Measure the resistance between spiral cable terminals 3 and 1 (part wiring harness-side) using a ohmmeter.
      GTY493565Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      • If as specified, go to the next step.
      • If not as specified, replace the steering pad switch.

        Refer to REMOVAL

      Switch condition Resistance (ohm)
      Cruise OFF switch held at on Continuity
      CANCEL switch held at on Approx. 84.5
      SET (-) switch held at on Approx. 189.5
      SET (+) switch held at on Approx. 326.5
      RESUME (RES) switch held at on Approx. 506.5
      Cruise ON switch held at on Approx. 761.5
      Neutral Approx. 3, 311.5
    5. Apply battery positive voltage to spiral cable terminal 10 (part wiring harness-side), and terminal 8 (part wiring harness-side) to ground.
      GTY489672Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    6. Verify that the LED illuminates.
      • If the LED does not illuminate, replace the steering pad switch.

        Refer to REMOVAL