Terminals Of Ecu
- CHECK 4WD CONTROL ECU
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TEXT IN ILLUSTRATION*a Component without harness connected
(4WD Control ECU)- - - Measure the voltage and resistance of the connector.
Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition K1-14 (CANH) - K1-16 (CANL) L - W CAN communication Ignition switch off 54 to 69 Ω K1-23 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω K1-11 (IG1) - K1-23 (GND) L - W-B Power source voltage Ignition switch ON 11 to 14 V K1-13 (SLC+) - K1-32 (SLC-) W - B Electromagnetic solenoid signal D position, Idling Pulse generation
(See waveform 1Fig 2)K1-9 (BSLC) - K1-23 (GND) R - W-B Power source voltage Always 11 to 14 V If the result is not as specified, the 4WD control ECU may have a malfunction.
- Using an oscilloscope, check the waveform 1.WAVEFORM 1 (REFERENCE)
Item Content Terminal No. (Symbol) SLC+ - SLC- Tester Range 5 V/DIV., 1 msec./DIV. Condition D position, Idling
- Measure the voltage and resistance of the connector.