LEMON Manuals: Even more car manuals for everyone

Front Airbag Sensor: Removal: Removal

HINT: 

  1. PRECAUTION 
    WARNING:

    Be sure to read Precaution thoroughly before servicing. Refer to PRECAUTION .

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  3. REMOVE COOL AIR INTAKE DUCT SEAL  . Refer to REMOVAL - Step 1
  4. REMOVE RADIATOR GRILLE  . Refer to REMOVAL - Step 2
  5. REMOVE FRONT AIRBAG SENSOR 
    1. Disengage the 2 claws to separate the radiator side deflector LH as shown in the illustration.
      Fig 1: Identifying 2 Claws
      GTY248858Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Check that the ignition switch is off.
    3. Check that the cable is disconnected from the negative (-) battery terminal.
      WARNING:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    4. Disconnect the connector from the front airbag sensor.
      NOTE:

      When disconnecting the airbag connector, take care not to damage the airbag wire harness.

      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)
        Fig 2: Pushing Down White Housing Lock And CPA (Yellow)
        GTY253798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      2. Push down the white housing lock again and disconnect the connector.
        NOTE:

        Do not push down part (A) shown in the illustration when disconnecting.

      3. After disconnecting the connector, check that the position of the white housing lock is correct as shown in the illustration.
        Fig 3: Identifying Housing Lock Position (White Part)
        GTY108678Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the bolt and front airbag sensor from the body.
      Fig 4: Locating Bolt And Front Airbag Sensor
      GTY252822Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Loosen the bolt while holding the front airbag sensor because the front airbag sensor pin (stopper) is easily damaged.