Tire Pressure Sensor Registration
NOTE:
Retrieve the sensor transmitter ID(s) using Techstream or by reading the ID on the tire pressure sensor if it is being replaced with a new one, make a note of the 7-digit number (transmitter ID) before installation, as it cannot be seen after sensor is installed. See Figure.
- Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
- Ensure ignition switch is OFF.
- Connect Techstream to DLC3.
- Turn ignition switch ON.
- Turn Techstream ON.
- Perform the transmitter ID registration. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
- Input the transmitter IDs using the Techstream and transmit them to the tire pressure warning ECU.
- The "ID Registration is complete" is displayed on the Techstream display.
- Confirm that expected tire pressure data from all wheels is displayed on the Techstream display. Check the Data List. Enter the following menus: Chassis / Tire Pressure Monitor / Data List.NOTE:
- It may take about 2 or 3 minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2124/24.
- If the IDs have not been registered, DTC C2171/71 will be stored in the tire pressure warning ECU after 3 minutes or more.
- If expected pressure values are displayed, the IDs have been registered correctly.
- If the tire pressure values are not displayed after a few minutes, the IDs may be incorrect or the system may have a malfunction.
- After all IDs are registered, DTC C2126/26 (Transmitter ID not Received) is stored in the tire pressure warning ECU and the tire pressure warning light blinks for 1 minute and then comes on. When the tire pressure warning ECU successfully receives radio waves from all the transmitters whose IDs are stored in the ECU, DTC C2126/26 is deleted and the tire pressure warning light goes off.