LEMON Manuals: Even more car manuals for everyone

Throttle Body: Removal: Removal

  1. DRAIN COOLANT (for Engine)  . Refer to REPLACEMENT - Step 1
  2. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY  . Refer to REMOVAL - Step 25
  3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY 
    1. Disconnect the mass air flow meter connector and wire harness clamp from the air cleaner cap sub-assembly.
      Fig 1: Identifying Mass Air Flow Meter Connector And Wire Harness Clamp
      GTY319925Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the ventilation hose from the cylinder head cover.
    3. Disconnect the connector and wire harness clamp.
    4. Release the 2 clamps and remove the air cleaner cap sub-assembly.
      Fig 2: Identifying Air Cleaner Cap Clamps
      GTY316092Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Disconnect the 2 fuel vapor feed hoses.
      Fig 3: Disconnecting Fuel Vapor Feed Hoses
      GTY320865Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      TEXT IN ILLUSTRATION

      *1 Retainer
      *2 Fuel Tube Connector
      *3 Pipe
      *4 O-ring
      *a Pinch
      *b Pull
      NOTE:
      • Remove any dirt or foreign matter on the fuel tube connector before performing this work.
      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tube connector has an O-ring that seals the pipe.
      • Perform this work by hand. Do not use any tools.
      • Protect the disconnected parts by covering them with plastic bags after disconnecting each fuel vapor feed hose.
    6. Loosen the hose clamp and disconnect the air cleaner hose from the throttle with motor body assembly.
      Fig 4: Identifying Air Cleaner Hose Hose Clamp
      GTY322171Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY 
    1. Disconnect the 2 hoses.
      Fig 5: Identifying Throttle Body Hoses
      GTY322172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Disconnect the throttle body connector.
      Fig 6: Identifying Throttle Body Connector And Water By-Pass Hoses
      GTY316095Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.
    4. Remove the 4 bolts and the throttle body with fuel tube bracket.
      Fig 7: Identifying Throttle Body Bolts
      GTY316247Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    5. Remove the gasket from the intake manifold.
      Fig 8: Identifying Throttle Body Gasket
      GTY316094Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002