LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P011B) 
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Select the following menu items: Powertrain/Engine and ECT/Trouble Codes.
    5. Read DTCs.

      Result 

      RESULT REFERENCE

      Display (DTC Output) Proceed To
      P011B A
      P011B and other DTCs B

      HINT:

      If any DTCs other than P011B are output, troubleshoot those DTCs first.

      B: GO TO DTC CHART 

      A: Go to next step 

  2. READ VALUE USING TECHSTREAM (INTAKE AIR TEMPERATURE) 
    1. Leave the vehicle for 7 hours or more.

      HINT:

      It is necessary leave the vehicle for 7 hours or more to allow conditions similar to the DTC detection conditions.

    2. Connect a Techstream to the DLC3.
    3. Turn the ignition switch to ON.
    4. Turn the tester ON.
    5. Select the following menu items: Powertrain/Engine and ECT/All Data/Intake Air.
    6. Read the value displayed on the tester.

      OK: The difference between the intake air temperature and the actual outside air temperature is within 10°C (18°F). 

      HINT:

      Temperature readings on the vehicle's outside temperature gauge (if equipped) are not suitable for comparing to the IAT reading. The outside temperature gauge has a significant delay built in to prevent swings in the temperature display. Use an accurate thermometer to determine the outside air temperature.

      NG: REPLACE MASS AIR FLOW METER (See  REMOVAL   ) 

      OK: Go to next step 

  3. READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) 
    1. Connect a Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the tester ON.
    4. Select the following menu items: Powertrain/Engine and ECT/All Data/Coolant Temp.
    5. Read the value displayed on the tester.

      OK: The difference between the coolant temperature and the actual outside air temperature is within 10°C (18°F). 

      HINT:

      If the result is not as specified, check that there are no heat sources such as a block heater in the engine compartment.

      NG: REPLACE ENGINE COOLANT TEMPERATURE SENSOR (See  REMOVAL   ) 

      OK: REPLACE ECM (See  REMOVAL   )