LEMON Manuals: Even more car manuals for everyone

Check For Intermittent Problems

  1. CHECK FOR INTERMITTENT PROBLEMS 

    HINT:

    A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the ECU Data List function of the Tech stream.

    1. Turn the ignition switch off and connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON. Follow the directions on the Techstream to display the Data List and select areas where momentary interruption should be monitored.

      HINT:

      • A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
      • If the status remains on (error displayed), check the continuity between the ECU and the sensors, or between ECUs.
      • The "Error" display on the Techstream remains on for 1 second after the harness signal changes from momentary interruption (open circuit) to normal condition.
        Fig 1: Identifying Momentary Interruption Blinking Pattern
        G06131971Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      ABS/VSC/TRC 

      ABS/VSC/TRC - DATA LIST

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      FR Speed Open FR speed sensor open detection/Error or Normal Error: Momentary interruption
      Normal: Normal
      -
      FL Speed Open FL speed sensor open detection/Error or Normal Error: Momentary interruption
      Normal: Normal
      -
      RR Speed Open RR speed sensor open detection/Error or Normal Error: Momentary interruption
      Normal: Normal
      -
      RL Speed Open RL speed sensor open detection/Error or Normal Error: Momentary interruption
      Normal: Normal
      -
    3. While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

      OK: Error display does not change. 

      HINT:

      If the display changes, the connector and/or the wire harness has caused a momentary interruption of the circuit. Repair or replace the connector and/or wire harness because one of them is faulty.

  2. SYMPTOM SIMULATION 

    Refer to How to Proceed with Troubleshooting (See HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS ).

    Fig 2: Inspecting Connector And Wire Harness Between ECU Or Sensors
    G05389424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002