LEMON Manuals: Even more car manuals for everyone

Starting System: Inspection

WARNING: This page is about a different variant/trim than selected.
  1. INSPECT STARTER ASSEMBLY 
    NOTE: These tests must be performed within 3 to 5 seconds to avoid burning out the coil.
    1. Perform the pull-in test.
      1. Disconnect the field coil lead wire from terminal C.
      2. Connect the battery to the magnetic switch as shown in the illustration. Check that the clutch pinion gear protrudes.
      Fig 1: Inspecting Starter Pull-In
      G06088797Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Perform the hold-in test.
      1. Disconnect the negative (-) lead from terminal C with the above condition (a) being sustained. Check that the pinion gear remains extended.
      Fig 2: Inspecting Starter Hold-In
      G06088798Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Check the operation.
      1. Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.
      Fig 3: Checking Starter Operation - Negative (-) Lead Disconnected
      G06088799Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Perform the operation test without any load.
      1. Connect the field coil lead wire to terminal C.

        Torque: 5.9 N*m (60 kgf*cm, 52 in.*lbf) 

      2. Clamp the starter in a vise.
      3. Connect the battery and ammeter to the starter as shown in the illustration.
      4. Check that the ammeter indicates the specified current.

        Specified current: 

        100 A or less at 11.5 V 

        Fig 4: Inspecting Starter Operation Test Without Any Load
        G06088800Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002