LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

WARNING: This page is about a different variant/trim than selected.

HINT:

  1. REPLACE ECM 
    1. Replace the ECM (See REMOVAL  ).
  2. CHECK WHETHER DTC OUTPUT RECURS 
    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Clear DTCs (See DTC CHECK/CLEAR  ).
    4. Start the engine and wait for 10 minutes or more.
    5. On the Techstream, enter the following menus: Powertrain/Engine and ECT/Trouble Codes/Pending.
    6. If no pending DTC is displayed, the repair has been successfully completed.

      NEXT: END