LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

HINT:

Read freeze frame data using the Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

  1. CHECK OPERATION OF SPEEDOMETER 
    1. Drive the vehicle and check if the operation of the speedometer in the combination meter is normal.

      HINT:

      The vehicle speed sensor is operating normally if the speedometer reading is normal.

      NG: CHECK SPEEDOMETER CIRCUIT  (See SPEEDOMETER MALFUNCTION )

      OK: Go to Next Step 

  2. INSPECT ECM (SPD VOLTAGE) 
    1. Move the shift lever to N.
    2. Jack up the vehicle.
    3. Turn the ignition switch to ON.
    4. Measure the voltage according to the value(s) in the table below.

      Standard 

      VOLTAGE SPECIFICATION

      Tester Connection Switch Condition Specified Condition
      E13-18 (SPD) - E11-12 (E1)
      • Ignition switch ON
      • Wheel turned slowly
      Voltage generated intermittently

      HINT:

      The output voltage should fluctuate up and down similarly to the diagram on the left when the wheel is turned slowly.

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      Fig 1: Wheel Voltage Output Fluctuate Up And Down Diagram
      G06080073Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: REPLACE ECM  (See ECM  )