LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

HINT:

Read freeze frame data using the Techstream. Freeze frame data record the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

  1. INSPECT ECM (FPR VOLTAGE) 
    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage 

      STANDARD VOLTAGE SPECIFICATION

      Tester Connection Condition Specified Condition
      E14-8 (FPR) - E11-12 (E1) STA signal ON 11 to 14 V
      E14-8 (FPR) - E11-12 (E1) STA signal OFF 0 to 3 V

      NG: REPLACE ECM  (See ECM  )

      Fig 1: Identifying E14 And E11 ECM Connectors
      G06079998Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: Go to Next Step 

  2. INSPECT FUEL PUMP RELAY ASSEMBLY 
    1. Remove the fuel pump relay from the engine room relay block.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      3 - 4 When battery voltage absent Below 1 Ω
      3 - 5 10 kΩ or higher
      3 - 5 When battery voltage applied to terminals 1 and 2 Below 1 Ω
      3 - 4 10 kΩ or higher
    3. Reinstall the fuel pump relay.

      NG: REPLACE FUEL PUMP RELAY ASSEMBLY 

      Fig 2: Fuel Pump Relay Circuit Diagram
      G04829434Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: Go to Next Step 

  3. CHECK HARNESS AND CONNECTOR (F/PMP RELAY - ECM) 
    1. Remove the fuel pump relay from the engine room relay block.
    2. Disconnect the ECM connector.
    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open) 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      1 (Fuel pump relay) - E14-8 (FPR) Always Below 1 Ω

      Standard Resistance (Check for Short) 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      1 (Fuel pump relay) or E14-8 (FPR) - Body ground Always 10 kΩ or higher
    4. Reinstall the fuel pump relay.
    5. Reconnect the ECM connector.

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      Fig 3: Identifying Fuel Pump Relay And ECM Connector
      G06080000Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      OK: REPLACE ECM  (See ECM  )