LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. INSPECT RADIO RECEIVER ASSEMBLY 
    1. Disconnect the R1 radio receiver assembly connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      R1-5 (TX+) - R1-15 (TX-) Always 60 to 80 Ω
    3. Reconnect the radio receiver assembly connector.

    NG: REPLACE RADIO RECEIVER ASSEMBLY  (See REMOVAL )

    Fig 1: Identifying R1 Radio Receiver Assembly Connector Terminals
    G06084739Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    OK: Go to next step. 

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - COMPONENT WHICH HAS STORED THIS CODE) 
    Fig 2: AVC-LAN Wiring Diagram
    G06084669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    HINT:

    For details of the connectors, refer to "Terminals of ECU" (See TERMINALS OF ECU ).

    1. Referring to the AVC-LAN wiring diagram below, check all AVC-LAN circuits.
      1. Disconnect all connectors in all AVC-LAN circuits.
      2. Check for an open or short in all AVC-LAN circuits.

        OK: There is no open or short circuit. 

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE  (See PROBLEM SYMPTOMS TABLE )