Inspection Procedure
NOTE:
If the steering column or power steering ECU is replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (See CALIBRATION
).
- CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
- Check if DTC U0129 is output.
Result
RESULT REFERENCEResult Proceed to DTC is not output A U0129 is output B HINT:
DTC U0129 indicates a VSC ECU communication malfunction in the power steering system.
B: GO TO CAN COMMUNICATION SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to Next Step
- Check if DTC U0129 is output.
- CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
- Check for DTCs of the ABS or VSC.
Result
RESULT REFERENCEResult Proceed to DTC is not output A C0200 or C0210 is output (with ABS) B C0200 or C0210 is output (with ABS) C HINT:
These DTCs indicate a speed sensor signal malfunction in the ABS or VSC.
NOTE: If the power steering ECU is replaced, initialize the rotation angle sensor and calibrate the torque sensor zero point (See CALIBRATION ).B: REPAIR CIRCUIT INDICATED BY OUTPUT CODE (for ABS) (See DIAGNOSTIC TROUBLE CODE CHART )
C: REPAIR CIRCUIT INDICATED BY OUTPUT CODE (with VSC) (See DIAGNOSTIC TROUBLE CODE CHART )
A: REPLACE POWER STEERING ECU (See POWER STEERING ECU )
- Check for DTCs of the ABS or VSC.