LEMON Manuals: Even more car manuals for everyone

Yaw Rate Sensor: Installation

  1. INSTALL YAW RATE SENSOR 
    1. Connect the yaw rate sensor connector.
    2. Install the yaw rate sensor with the bolt, nut, and clamp.

    Torque: 13.5 N*m (138 kgf*cm, 10 ft.*lbf) 

    Fig 1: Installing Yaw Rate Sensor
    G04443491Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL CENTER PILLAR GARNISH LOWER RH 
    1. Engage the 2 clips and 3 claws, install the center pillar garnish lower.
  3. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH  INSTALLATION 
  4. INSTALL FRONT DOOR SCUFF PLATE RH  INSTALLATION 
  5. INSTALL REAR DOOR SCUFF PLATE RH 
    1. Connect the connector. (w/ illumination scuff plate)
    2. Engage the 4 claws and 2 clips, and install the rear door scuff plate.
  6. INSTALL CONSOLE BOX ASSEMBLY (See step 11 in  INSTALLATION  ) 
  7. INSTALL FLOOR CARPET COVER CENTER RH (See step 14 in  INSTALLATION  ) 
  8. INSTALL FLOOR CARPET COVER CENTER LH (See step 13 in  INSTALLATION  ) 
  9. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER (See step 15 in  INSTALLATION  ) 
  10. INSTALL FRONT SEAT ASSEMBLY RH (for Manual Seat) 

    HINT:

    Use the same procedures for the RH side and LH side.

    w/o Front Seat side Airbag (See step 1 in INSTALLATION )

    w/ Front Seat side Airbag (See step 2 in INSTALLATION )

  11. INSTALL FRONT SEAT ASSEMBLY RH (for Power Seat) 

    HINT:

    Use the same procedures for the RH side and LH side.

    w/o Front Seat side Airbag (See step 1 in INSTALLATION )

    w/ Front Seat side Airbag (See step 2 in INSTALLATION )

  12. INSTALL SEAT TRACK BRACKET COVER OUTER 

    HINT:

    Use the same procedures for the RH side and LH side.

    For Manual Seat (See INSTALLATION )

    For Power Seat (See INSTALLATION )

  13. INSTALL SEAT TRACK BRACKET COVER INNER FRONT 

    HINT:

    Use the same procedures for the RH side and LH side.

    For Manual Seat (See INSTALLATION )

    For Power Seat (See INSTALLATION )

  14. INSTALL SEAT TRACK COVER LH 

    HINT:

    Use the same procedures for the RH side and LH side.

    For Manual Seat INSTALLATION

    For Power Seat INSTALLATION

  15. INSTALL SEAT TRACK COVER RH 

    HINT:

    Use the same procedures for the RH side and LH side.

    For Manual Seat INSTALLATION

    For Power Seat INSTALLATION

  16. PERFORM YAW RATE SENSOR ASSEMBLY ZERO POINT CALIBRATION 

    CALIBRATION 

  17. INSPECT ABS WARNING LIGHT AND VSC WARNING LIGHT 

    TEST MODE PROCEDURE 

  18. INSPECT SRS WARNING LIGHT  DIAGNOSIS SYSTEM 
  19. PERFORM INITIALIZATION 

    Some systems need initialization after reconnecting the negative battery cable.

    INITIALIZATION

  20. INSPECT POWER SEAT OPERATION (for Power Seat) (See  SYSTEM DESCRIPTION  ) 
  21. INSPECT SLIDE ADJUSTER LOCK SIMULTANEOUSLY (for Manual Seat) (See  INSTALLATION  ) 
  22. INSPECT SEAT HEATER (w/ Seat Heater System)