LEMON Manuals: Even more car manuals for everyone

DTC Check / Clear

  1. DTC CHECK/CLEAR (WHEN USING INTELLIGENT TESTER): 
    1. DTC check
      1. Connect the intelligent tester to the DLC3.
      2. Turn the ignition switch on.
      3. Read the DTCs following the prompts on the tester screen.
    2. DTC clear
      1. Connect the intelligent tester to the DLC3.
      2. Turn the ignition switch on.
      3. Operate the intelligent tester to clear the codes.

      HINT:

      Refer to the intelligent tester operator's manual for further details.

      Fig 1: Connecting Intelligent Tester To DLC3
      G04443335Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fig 2: Identifying Terminals TS And CG Of DLC3
      G04443336Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE): 
    1. DTC check
      1. Using SST, connect terminals TC and CG of the DLC3.

        SST 09843-18040 

      2. Turn the ignition switch on.
      3. Read DTC from the ABS and brake control warning lights on the combination meter and multi information display.

        HINT:

        Fig 3: Identifying Blinking Patterns Of Normal System Code And Trouble Codes 31 And 43
        G04443337Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      4. Codes are explained in the code table DIAGNOSTIC TROUBLE CODE CHART 
      5. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display. If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.
    2. DTC clear
      1. Using SST, connect terminals TC and CG of the DLC3.

        SST 09843-18040 

      2. Turn the ignition switch on.
        Fig 4: Identifying Terminals TS And CG Of DLC3
        G04443338Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
        Fig 5: Checking That ABS Warning And Brake Control Lights
        G04443339Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      3. Clear the DTCs stored in the ECU by depressing the brake pedal 8 times or more within 5 seconds.
      4. Check that the ABS warning and brake control lights and multi information display indicate the normal system code.
      5. Remove the SST from the terminals of the DLC3.

      HINT:

      Clearing the DTCs cannot be performed by removing the battery cable or the ECU-IG NO.1 fuse.

  3. END OF DTC CHECK/CLEAR (WHEN USING SST CHECK WIRE): 
    1. Turn the ignition switch on.
    2. Check that the ABS and brake control warning lights go off within approximately 3 seconds.