Chapter 1: Electronic Circuit Matrix Chart
- Refer to the table below when the trouble cause is considered to be electrical.
- If the instruction "Proceed to next circuit inspection shown on matrix chart" is given in the flow chart of each circuit, proceed to the circuit with the next highest number in the table to continue the check.
- If the trouble still occurs even though there are no abnormalities in any of the other circuits, check and replace the ECM.
HINT:
*1: When the circuit on which mark *1 is attached is defective, DTC could be output (see DIAGNOSTIC TROUBLE CODE CHART ).
PROBLEM SYMPTOMS TABLE - AUTOMATIC TRANSMISSION (ELECTRONIC CIRCUITS)Symptom Suspect Area No up-shift (A particular gear, from 1st to 4th gear, is not up-shifted) - Shift solenoid valve (S1) circuit *1
- Shift solenoid valve (S2) circuit *1
- BCM
No up-shift (4th → 5th) - O/D main switch circuit
- Engine coolant temp, sensor circuit *1
- Speed sensor NT circuit*1
- Shift solenoid valve (SL1) circuit *1
- Shift solenoid valve (SL2) circuit *1
- Shift solenoid valve (SR) circuit*1
- ECM
No up-shift (3rd → 4th) - Engine coolant temp, sensor circuit *1
- Shift solenoid valve (S2) circuit *1
- ECM
No up-shift (1st → 2nd) - Shift position L switch circuit
- Shift solenoid valve (S2) circuit *1
- ECM
No down-shift (5th → 4th) - O/D main switch circuit
- Shift solenoid valve (SL1) circuit *1
- Shift solenoid valve (SL2) circuit *1
- Shift solenoid valve (SR) circuit*1
- ECM
No down-shift (2nd → 1st) - Shift position L switch circuit
- Shift solenoid valve (S2) circuit *1
- ECM
No down-shift (A particular gear, from 1st to 4th gear, is not down-shifted) - Shift solenoid valve (S1) circuit*1
- Shift solenoid valve (S2) circuit *1
- ECM
No lock-up - ATF temperature sensor circuit*1
- Stop light switch circuit *1
- Speed sensor NT circuit *1
- Shift solenoid valve (SLU) circuit *1
- Engine coolant temp, sensor circuit *1
- ECM
No lock-up off - 4. Shift solenoid valve (SLU) circuit *1
- 6. ECM
Shift point too high or too low - Shift solenoid valve (SLT) circuit*1
- Speed sensor NT circuit *1
- Speed sensor SP2 circuit *1
- Throttle position sensor circuit *1
- ATF temperature sensor circuit *1
- ECM
Up shift to 5th from 4th while shift lever is in 4 position - O/D main switch circuit
- ECM
Up-shift to 5th from 4th while engine is cold - Engine coolant temp, sensor circuit*1
- ECM
Up-shift to 4th from 3rd while shift lever is in 3 position - Park/neutral position switch circuit*1
- ECM
Up-shift to 3rd from 2nd while shift lever is in 2 position - Park/neutral position switch circuit*1
- ECM
Up-shift to 2nd from 1st while shift lever is in L position - Shift position L switch circuit
- ECM
Harsh engagement (N → D) - Speed sensor NT circuit *1
- Shift solenoid valve (SL1) circuit *1
- Shift solenoid valve (SLT) circuit *1
- ECM
Harsh engagement (Lock-up) - Speed sensor NT circuit *1
- Speed sensor SP2 circuit *1
- Shift solenoid valve (SLU) circuit *1
- ECM
Harsh engagement (Any driving position) ECM Poor acceleration - ATF temperature sensor No.2 circuit *1
- Engine coolant temp, sensor circuit *1
- Shift solenoid valve (SL1) circuit*1
- ECM
No engine braking ECM No kick-down ECM Engine stalls when starting off or stopping - Shift solenoid valve (SLU) circuit *1
- ECM
AT Oil Temp, warning light remains on - ATF temperature sensor No.2 circuit *1
- Engine coolant temp, sensor circuit *1
- ECM
Lock-up at 3rd gear Shift point too high Malfunction in shifting - Park/neutral position switch circuit*1
- ECM