LEMON Manuals: Even more car manuals for everyone

Air-Fuel Ratio (A/F) Sensor: Inspection

  1. INSPECT HEATER RESISTANCE OF AIR FUEL RATIO SENSOR 
    1. Disconnect the air fuel ratio sensor connector.
    2. Using an ohmmeter, measure the resistance between terminals +B and HT.
      Fig 1: Measuring Resistance Between Terminals +B And HT
      G02650668Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Resistance 11 to 16 k Ω at 20° C (68° F) 

      If the resistance is not as specified, replace the sensor.

      Torque: 44 N.m (450 kgf.cm, 32 ft.lbf) 

    3. Reconnect the air fuel ratio sensor connector.
  2. INSPECT OPERATION OF AIR FUEL RATIO SENSOR (See  DTC P0031, P0032, P0051, P0052: OXYGEN (A/F) SENSOR HEATER CONTROL CIRCUIT LOW/HIGH (BANK 1 & 2 SENSOR 1)  ) 
  3. INSPECT AIR-FUEL RATIO COMPENSATION SYSTEM 
    1. Measure the voltage between the terminals of the ECM connectors.
      Fig 2: Identifying ECM Connector Terminals
      G02650669Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      Standard: 

      VOLTAGE CHECK SPECIFIED CONDITION

      Tester Connection Condition Specified Condition
      B2-22 (A1A+) - B1-1 (E1) Ignition switch ON 3.3 V
      B2-30 (A1A-) - B1-1 (E1) Ignition switch ON 2.9 V
      B2-23 (A2A+) - B1-1 (E1) Ignition switch ON 3.3 V
      B2-31 (A2A-) - B1-1 (E1) Ignition switch ON 2.9 V
      NOTE: Connect test leads from the back side of the connector. The connectors should not be disconnected from the ECM.

      HINT:

      The voltage between the terminals of the ECM is kept constant regardless of the voltage of the A/F sensor.

    2. Connect a hand-held tester to the Controller Area Network Vehicle Interface Module (CAN VIM). Then connect the CAN VIM to the Date Link Connector 3 (DLC3).
      Fig 3: Connecting Hand-Held Tester To Date Link Connector (DLC3)
      G02650670Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Turn the ignition switch ON.
    4. Select the following menu items: Data List / A/FS B1 S1 and O2S B1 S2.
    5. Warm up the A/F sensor by running the engine at 2,500 RPM for approximately 2 minutes.
    6. Keep the engine speed at 2,500 RPM and confirm that the display of the "A/FS B1 S1" is as shown in the illustration.

      HINT:

      • The illustration may slightly differ from the display on the hand-held tester.
      • The waveform of the A/F sensor is displayed only on the hand-held tester.
      • Fig 4: Identifying Waveform (A/F Sensor)
        G02650671Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    7. Confirm that the display of the "O2S B1 S2" changes between 0 and 1 V with the engine speed at 2,500 RPM.

      OK: The voltage output oscillates more than 8 times in 10 seconds. 

      CAUTION: