LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. Check fuse. 

    CHECK: 

    Measure the resistance of the IGN2 fuse and IGN1 fuse in the instrument panel J/B.

    OK: 

    Below 1 Ω 

    CHECK: 

    Measure the resistance of the STA fuse in the engine room R/B.

    OK: 

    Below 1 Ω 

    CHECK: 

    Measure the resistance of the ECU-B fuse and AM2 fuse in the engine room R/B.

    OK: 

    Below 1 Ω 

    1. NG: Inspect for short circuit in harness and all components connected to fuse. 
    2. OK: Go to next step. 
  2. Inspect combination meter (Power source). 

    PREPARATION: 

    Disconnect the combination meter connectors.

    CHECK: 

    Measure the resistance according to the value(s) in the table below.

    OK: 

    TERMINAL SPECIFIED CONDITION CHART

    Terminal No Condition Specified condition
    C6-12 - Body ground Always Below 1 Ω
    Fig 1: Disconnecting Combination Meter Connectors (1 Of 2)
    G03057284Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    CHECK: 

    Measure the voltage according to the value(s) in the table below.

    OK: 

    TERMINAL SPECIFIED CONDITION CHART

    Terminal No Condition Specified condition
    C6-23 - Body ground Always 10 to 14 V
    C5-28 - Body ground Ignition switch ON 10 to 14 V
    C6-24 - Body ground Ignition switch ON 10 to 14 V
    C5-3 - Body ground Ignition switch ST 10 to 14 V
    Fig 2: Disconnecting Combination Meter Connectors (2 Of 2)
    G03057285Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. NG: Repair or replace harness or connector. 
    2. OK: Replace combination meter (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ).