LEMON Manuals: Even more car manuals for everyone

Inspection Procedure

  1. CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF 
    1. After turn the power switch OFF:
      1. Either front door is opened within 43 seconds but the power window can still operate. Proceed to A.
      2. 43 seconds pass and the power window can still operate. Proceed to B.

    B: REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSY 

    A: Go to next step. 

  2. READ VALUE OF HAND-HELD TESTER 
    1. Connect the hand-held tester (with CAN VIM) to the DLC3.
    2. Turn the power switch ON (IG) and press the hand-held tester main switch ON.
    3. Read the DATA LIST according to the displays on the tester.

      Multiplex network body ECU: 

      ITEM DISPLAY

      Item Measurement Item/Range (Display) Normal Condition
      D DOR CTY SW Driver side door courtesy switch signal/ON or OFF ON: Driver side door is open OFF: Driver side door is closed
      P DOR CTY SW Passenger side door courtesy switch signal/ON or OFF ON: Passenger side door is open OFF: Passenger side door is closed

      OK: "ON" (door is open) appears on the screen. 

    NG: Go to step 3 

    OK: REPLACE INSTRUMENT PANEL J/B 

  3. INSPECT FRONT DOOR COURTESY LAMP SWITCH ASSY 
    1. Remove the courtesy D7 or D8 lamp switch.
    2. Measure the switch resistance.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Switch Condition Specified Condition
      1 - Switch body Pushed 10 kΩ or higher
      1 - Switch body Not pushed Below 1 Ω
    Fig 1: Inspecting Front Door Courtesy Lamp Switch
    G02919610Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPLACE FRONT DOOR COURTESY LAMP SWITCH ASSY 

    OK: Go to next step. 

  4. CHECK WIRE HARNESS (FRONT DOOR COURTESY LAMP SWITCH ASSY - INSTRUMENT PANEL J/B ASSY) 
    1. Disconnect the D7 or D8 lamp switch connector.
    2. Disconnect the 1D J/B connector.
    3. Measure the resistance of the wire harness side connectors.

      Standard: 

      TESTER CONNECTION SPECIFIED CONDITION

      Tester Connection Specified Condition
      D7-1 - 1D-21 Below 1 Ω
      D8-1 - 1D-24 Below 1 Ω
      D7-1 - Body ground 10 kΩ or higher
      D8-1 - Body ground 10 kΩ or higher
    Fig 2: Identifying D7 Or D8 Lamp Switch Connector And 1D J/B Connector
    G02919611Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS AND CONNECTOR 

    OK: REPLACE INSTRUMENT PANEL J/B ASSY