LEMON Manuals: Even more car manuals for everyone

Fuel Injector ASSY (2AZ-FE): Replacement

  1. WORK FOR PREVENTING GASOLINE FROM SPILLING OUT (See  FUEL SYSTEM (2AZ-FE)  ) 
  2. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE 
  3. REMOVE ENGINE COVER SUB-ASSY NO.1 
  4. DISCONNECT FUEL TUBE SUB-ASSY (See  REPLACEMENT  ) 
  5. REMOVE FUEL DELIVERY PIPE W/INJECTOR 
    NOTE: Be careful not to drop the injectors when removing the delivery pipe.
    1. Remove the ventilation hose No. 2.
    2. Disconnect the 4 injector connectors from the injector.
    3. Remove the 2 clamps and wire harnesses from the delivery pipe.
      Fig 1: Removing Fuel Delivery Pipe W/Injector
      G02596809Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Remove the 2 bolts and the delivery pipe together with the 4 injectors.
    5. Remove the 2 spacers from the cylinder head.
  6. REMOVE FUEL INJECTOR ASSY 
    1. Pull out the 4 injectors from the delivery pipe.
  7. INSTALL FUEL INJECTOR ASSY 
    1. Install a new insulator to each injector.
    2. Apply a light coat of grease or gasoline to a new O-ring and install to each injector.
      Fig 2: Installing Insulator To Injector
      G02596810Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Apply a light coat of grease or gasoline on the place where a delivery pipe touches the O-ring.
    4. To install the fuel injector into the fuel delivery pipe, push the fuel injector while twisting it back and forth.
    5. Install the 4 injectors.
      Fig 3: Installing Fuel Injector Into Fuel Delivery Pipe
      G02596811Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • Be careful not to twist the O-ring.
      • After installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
    6. Position the injector connector downward.
  8. INSTALL FUEL DELIVERY PIPE W/INJECTOR 
    1. Place the 2 spacers in position on the cylinder head.
    2. Place the delivery pipe together with the 4 injectors in position on the cylinder head.
      Fig 4: Placing Spacers In Position On Cylinder Head
      G02596812Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Temporarily install the 2 bolts holding the delivery pipe to the cylinder.
      Fig 5: Installing Bolts Holding Delivery Pipe To Cylinder
      G02596813Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE: After Installing the fuel injector, check that it turns smoothly. If not, reinstall it with a new O-ring.
    4. Position the injector connector outward.
    5. Tighten the 2 bolts holding the delivery pipe to the cylinder head.

      Torque: 20 N.m (204 kgf.cm, 15 ft.lbf) 

  9. CONNECT FUEL TUBE SUB-ASSY 
  10. INSPECT FOR FUEL LEAKS (See  ON-VEHICLE INSPECTION  ) 
  11. INSTALL ENGINE COVER SUB-ASSY NO.1 (See  REPLACEMENT  ) 
  12. INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE (See  REPLACEMENT  )