LEMON Manuals: Even more car manuals for everyone

Input Shaft: Inspection

  1. INSPECT SYNCHRONIZER RING 
    1. Check for wear or damage.
    2. Check the braking effect of the synchronizer ring. Turn the synchronizer ring in one direction while pushing it to the gear cone. Check that the ring locks.

      If the braking effect is insufficient, apply a small amount of the fine lapping compound between the synchronizer ring and gear cone. Lightly rub the synchronizer ring and gear cone together.

      NOTE: Ensure the fine lapping compound is completely washed off after rubbing.
    3. Check again the braking effect of the synchronizer ring.
      Fig 1: Checking Braking Effect Of Synchronizer Ring
      G02906387Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    4. Using a feeler gauge, measure the clearance between the synchronizer ring back and gear spline end.

      Minimum clearance: 0.75 mm (0.0295 in.) 

      If the clearance is less than the minimum, replace the synchronizer ring and apply a small amount of the fine lapping compound on gear cone

      NOTE: Ensure the fine lapping compound is completely washed off after rubbing.
      Fig 2: Measuring Clearance Between Synchronizer Ring Back And Gear Spline End
      G02906388Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSPECT SHIFT FORK AND HUB SLEEVE CLEARANCE 

    Using a feeler gauge, measure the clearance between the hub sleeve and shift fork.

    Maximum clearance: 0.35 mm (0.014 in.) 

    If the clearance exceeds the maximum, replace the shift fork or hub sleeve.

    Fig 3: Measuring Clearance Between Hub Sleeve And Shift Fork
    G02906389Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. INSPECT INPUT SHAFT 
    1. Check the input shaft for wear or damage.
    2. Using a micrometer, measure the outer diameter of the input shaft journal surface.

      Minimum outer diameter: 

      Part A: 24.885 mm (0.9797 in.) 

      Part B: 28.985 mm (1.1411 in.) 

      Part C: 30.985 mm (1.2199 in.) 

      Part D: 24.967 mm (0.9830 in.) 

      If the outer diameter is less than the minimum, replace the input shaft.

      Fig 4: Inspecting Input Shaft
      G02906390Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Using a dial indicator, check the shaft runout.

      Maximum runout: 0.03 mm (0.0012 in.) 

      If the runout exceeds the maximum, replace the input shaft.

      Fig 5: Checking Shaft Runout
      G02906391Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002