LEMON Manuals: Even more car manuals for everyone

Back Door (Hatchback): Disassembly

  1. w/ Rear wiper: 

    REMOVE REAR WIPER ARM 

    1. Remove the rear wiper head cap.
    2. Remove the nut and rear wiper arm.

      Torque: 5.5 N.m (55 kgf.cm, 48 in.lbf) 

      Fig 1: Removing Rear Wiper Arm
      G02907059Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      At the time of reassembly, please refer to the following item. Operate the wiper motor once and turn the wiper switch OFF before installing the wiper arm. Then install the wiper arm and tighten the nut by hand to adjust the wiper arm to the position as shown in Fig 2 .

      A: Approx. 53.8 mm (2.118 in.) 

    3. Remove the grommet.
  2. REMOVE PACKAGE TRAY TRIM PANEL 
    Fig 2: Precautions For Installing Rear Wiper Arm
    G02907060Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. REMOVE BACK DOOR TRIM BOARD 
    1. Using a clip remover, pull out the 8 clips.
    2. Remove the back door trim board.
      Fig 3: Removing Back Door Trim Board
      G02907061Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. w/ Rear wiper: 

    REMOVE REAR WIPER MOTOR 

    1. Remove the 2 bolts and loosen the bolt indicated by the arrow in Fig 4 .

      Torque: 5.5 N.m (55 kgf.cm, 48 in.lbf) 

    2. Disconnect the connector, then remove the rear wiper motor.
      Fig 4: Removing Rear Wiper Motor
      G02907062Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. REMOVE BACK DOOR LOCK ACTUATOR 
    1. Disconnect the connector.
    2. Remove the 2 bolts, then remove the back door lock actuator from the back door panel.

      Torque: 7.0 N.m (75 kgf.cm, 61 in.lbf) 

      Fig 5: Removing Back Door Lock Actuator
      G02907063Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE BACK DOOR LOCK 

    Remove the 3 bolts, then remove the back door lock.

    Torque: 7.0 N.m (75 kgf.cm, 61 in.lbf) 

  7. REMOVE BACK DOOR LOCK CYLINDER 
    1. Remove the bolt and back door lock cylinder.
    2. Remove the outside back door handle from the outside.
      Fig 6: Removing Back Door Lock
      G02907064Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      HINT:

      At the time of reassembly, turn the back door lock cylinder to the right end as shown in Fig 7 .

      Fig 7: Removing Back Door Lock Cylinder
      G02907065Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE PULL HANDLE 

    Using a screwdriver, remove the pull handle.

    HINT:

    Tape the screwdriver tip before use.

  9. REMOVE CENTER STOP LIGHT 
    1. Pull down the center stop light cover to remove it.
    2. Remove the 2 bolts and disconnect the connector.
    3. Remove the center stop light.
      Fig 8: Removing Pull Handle
      G02907066Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002