Test No. 5: Anti-Theft System Cannot Be Canceled When Ignition Is On
- If Toyota hand-held tester is available, go to next step. If Toyota hand-held tester is not available, go to step 3.
- Connect hand-held tester to Data Link Connector (DLC) No. 3. See Figure. Using hand-held tester manufacturer's instructions, check operation of key unlock warning switch while using the DATA LIST. Key unlock warning switch should be on when ignition key is in ignition lock cylinder and should be off when ignition key is removed from ignition lock cylinder. If key unlock warning switch does not operate properly, remove hand-held tester. Go to next step. If key unlock warning switch operates properly, remove hand-held tester. Go to step 5.
- Check key unlock warning switch. See KEY UNLOCK WARNING SWITCH under COMPONENT TESTS. If key unlock warning switch is okay, go to next step. If key unlock warning switch is defective, replace key unlock warning switch and recheck anti-theft system operation. See KEY UNLOCK WARNING SWITCH under REMOVAL & INSTALLATION.
- Check key unlock warning switch circuit by checking Yellow/Green wire and electrical connectors between terminal No. 2 at key unlock warning switch and terminal No. 22 at body Electronic Control Unit (ECU) electrical connector B7. See WIRING DIAGRAMS in POWER DOOR LOCKS & REMOTE KEYLESS ENTRY SYSTEMS - SEQUOIA article. Key unlock warning switch may also be referred to as unlock switch. Body ECU is located behind driver's side of instrument panel and contains 3 electrical connectors. See Figure. For body ECU electrical connector terminal identification, see Figure. If wiring harness and electrical connectors are okay, go to next step. If wiring harness or electrical connector is defective, repair as necessary and recheck anti-theft system operation.
- Check ignition switch. See IGNITION SWITCH under COMPONENT TESTS. If ignition switch is okay, go to next step. If ignition switch is defective, replace ignition switch and recheck anti-theft system operation. See IGNITION SWITCH under REMOVAL & INSTALLATION.
- Check body ECU for proper voltage and input signals. See BODY ELECTRONIC CONTROL UNIT under PIN VOLTAGE TESTS. If proper voltage and input signals exist, go to next step. If proper voltage and input signals do not exist, repair as necessary and recheck anti-theft system operation.
- Replace body ECU with a known-good body ECU and recheck anti-theft system operation. If anti-theft system operates properly, original body ECU was defective. If anti-theft system still does not operate properly, check wiring harness and electrical connectors for body ECU for intermittent problem. See WIRING DIAGRAMS in POWER DOOR LOCKS & REMOTE KEYLESS ENTRY SYSTEMS - SEQUOIA article. Repair wiring harness or electrical connector as necessary.