DTC B2795: Unmatched Ignition Key Code
NOTE:
DTC B2795 may be caused when ignition key that has not been registered is inserted into ignition lock cylinder. Possible cause is ignition key is not registered.
- Clear DTCs from Engine Control Module (ECM). See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM. Insert all available ignition keys in ignition lock cylinder and check whether engine will start. Recheck for DTCs. If ignition key that is not registered is inserted into ignition lock cylinder, DTC B2795 will be stored in ECM memory.
- If any ignition key does not start the engine and DTC B2795 is reset, go to next step. If all ignition keys start the engine, there is a possibility that the unregistered ignition key has been previously inserted into ignition lock cylinder and ECM is operating normally. Check with customer to verify ignition key usage.
- Once ignition key is found that does not start the engine and causes DTC B2795 to be reset, ignition key must be registered. See ADDITIONAL MASTER KEY REGISTRATION or ADDITIONAL SUB-KEY REGISTRATION under PROGRAMMING.