Turbo Pressure Sensor: Turbo
- Ensure ignition is off. To test turbo pressure sensor supply voltage, disconnect electrical connector from turbo pressure sensor. Turbo pressure sensor is mounted on intake manifold, near cable bracket. See Fig 1. Turbo pressure sensor contains a Black 3-pin electrical connector with White/Black, Black/Yellow and Blue/Red wires.
- Turn ignition on. Using voltmeter, check voltage between terminals VC and E2 of wiring harness side of the turbo pressure sensor electrical connector. The VC and E2 terminals are the outer terminals on each side of the electrical connector. DO NOT use the center terminal. Voltage should be 4.5-5.5 volts.
- If voltage is not within specification, check wiring circuit. See appropriate wiring diagram in WIRING DIAGRAMS article. If voltage is within specification, turn ignition off. Reinstall electrical connector on turbo pressure sensor.
- To test turbo pressure sensor output voltage, disconnect vacuum hose from turbo pressure sensor. Ensure ignition is off. Disconnect negative battery cable. Remove passenger's side door scuff plate.
- Remove carpet below instrument panel on passenger's side for access to Engine Control Module (ECM). The ECM is located on the floor panel, below the glove box and ECM protector. Remove ECM protector. Remove nuts and separate ECM from floor panel. Loosen bolt and disconnect electrical connectors from ECM.
- Install Check Harness (SST 09990-01000) between ECM and ECM electrical connectors. See Fig 2. Reinstall negative battery cable.
- Turn ignition on. Connect voltmeter between terminals PIM and E2 on check harness. See Fig 2. Measure and record turbo pressure sensor output voltage under ambient atmospheric pressure.
- Using vacuum pump, apply vacuum in specified increments and measure turbo pressure sensor output voltage drop at each increment. See TURBO PRESSURE SENSOR OUTPUT VOLTAGE SPECIFICATIONS table.TURBO PRESSURE SENSOR OUTPUT VOLTAGE SPECIFICATIONS
Applied Vacuum: In. Hg Output Voltage Drop 3.94 .15-.35 7.87 .40-.60 11.81 .65-.85 15.75 .90-1.10 19.69 1.15-1.35 - Replace turbo pressure sensor if turbo sensor output voltage drop is not within specification. Turn ignition off. Disconnect negative battery cable. Remove check harness. Reinstall all electrical connectors, ECM, vacuum hose and negative battery cable.