LEMON Manuals: Even more car manuals for everyone

Actuator Test

  1. Ensure battery voltage exists. Disconnect actuator and control relay electrical connectors. Connect Test Harness (09990-00200 and 09990-00300) and Actuator Checker (09990-00150) to vehicle, following manufacturer's instructions. Connect actuator checker positive and negative power cables to vehicle battery.
  2. Place Sheet "O" (09990-00420) on actuator checker. Start engine and let idle. Turn actuator checker SELECTOR switch to FRONT RH position. See Fig 1. Press and hold MOTOR switch for a few seconds. Press and hold brake pedal. Press the POWER Switch and ensure brake pedal cannot be depressed.
    NOTE: DO NOT press POWER switch for more than 10 seconds.
    Fig 1: Identifying Actuator Checker Switches
    G93G84695Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. With brake pedal still applied, release POWER switch and ensure brake pedal can be depressed. Press and hold MOTOR switch for a few seconds and ensure brake pedal returns. Release brake pedal.
  4. Press and hold MOTOR switch for a few seconds. Press and hold brake pedal for about 15 seconds. Press and hold MOTOR switch for a few seconds. While pressing brake pedal, press MOTOR switch for a few seconds. Brake pedal should not pulsate.
  5. Repeat steps 2) through 4) for FRONT LH, REAR RH and REAR LH by turning SELECTOR switch on actuator checker. When checking REAR LH position, press REAR LH POWER switch, instead of POWER switch.
  6. After checking remaining wheels, press and hold MOTOR switch for a few seconds. Stop engine. Remove actuator checker and test harnesses. Reconnect vehicle harnesses to actuator and control relay. Install windshield washer reservoir. Clear DTC. See CLEARING DTC under SELF-DIAGNOSTICS .