Test 3: Actuator Position Sensor Circuit
WARNING: This page is about a different variant/trim than selected.
- Disconnect actuator connector. Measure resistance between actuator terminal No. 1 (Red wire) and terminal No. 3 (Light Green/White wire). Ensure resistance is 1800-2200 ohms. If resistance is as specified, go to next step. If resistance is not as specified, replace cruise control actuator and retest system.
- Turn ignition switch to ON position and measure voltage between actuator connector terminal No. 2 (Red/White wire) and terminal No. 3 (Light Green/White wire). Move actuator control arm from closed position (deceleration side) to open position (acceleration side). Ensure voltage changes gradually from 1.3 volts (fully closed) to 4.6 volts (fully opened). If voltage is as specified, go to next step. If voltage is as specified, replace cruise control actuator and retest system.
- Check harness and connector between CC ECU and actuator position sensor. Repair or replace as necessary. Check for loose connections at harness and connector. If connections are okay, check CC ECU. See PIN VOLTAGE TESTS . If found to be defective, replace CC ECU and retest system.