Diagnosis & Repair
- Access ECM behind luggage compartment mat. Ensure ignition is off (LOCK position). Disconnect ECM harness connector. Using ohmmeter, measure resistance between terminal KNK and ground. See Figure (M/T) or 6 (A/T). If infinite resistance exists, go to step 3). If infinite resistance does NOT exist, go to next step.
- Remove knock sensor. Measure resistance between sensor terminal and sensor body. If infinite resistance exists, go to next step. If infinite resistance does NOT exist, replace knock sensor.
- Inspect circuit between knock sensor and ECM for open or short. See the WIRING DIAGRAMS - 2.2L (NON-TURBO) article. Repair as needed. If circuit is okay, go to next step.
- Install known good knock sensor and retest. If Code 52 is no longer present, replace sensor. If Code 52 is still present, replace ECM and retest.