Speed Sensor Diagnostics
NOTE:
While diagnosing speed sensors, brake system functions as a conventional system.
- Ensure battery voltage is about 12 volts. Turn ignition on. ABS light should come on then go out after 3 seconds. If ABS light does not operate as specified, check fuse, bulb, and wiring harness.
- Turn ignition off. Connect jumper wire between Data Link Connector 1 (DLC1) terminals "Ts" to "E1". See Figure. Engage parking brake. Start engine. DO NOT press brake pedal. ABS light will flash 4 times per second.
- Drive vehicle straight ahead faster than 28 MPH for a few seconds. Ensure ABS light turns off. If ABS light does not turn off, go to next step. If ABS light does not turn off, drive vehicle above 50 MPH for a few seconds. ABS light should flash one time then turn off. If ABS light performs as described, speed sensor system is okay.
- Stop engine and turn ignition off. Connect jumper wire between Data Link Connector 1 (DLC1) terminals "Tc" to "E1", leaving terminals "Ts" and "E1" connected. See Figure. If a DTC is stored, 4 seconds will elapse, then ABS light will begin to flash a 2-digit DTC. First group of flashes will indicate first digit in DTC. After a 1.5-second pause, second group of flashes will indicate second digit in a DTC.
- If 2 or more DTCs are stored, there will be a 2.5-second pause between each DTC. After all DTCs are flashed, there will be a 4-second pause, then all DTCs will repeat.
- Record DTCs. Turn ignition off. Repair as necessary. See SPEED SENSOR DIAGNOSTIC CODES . Remove jumper wires from DLC1. Clear DTCs. See CLEARING DTCS .