LEMON Manuals: Even more car manuals for everyone

Actuator Check

NOTE: Actuator Checker (09990-00150) is required to perform ACTUATOR CHECK.
  1. Ensure battery voltage exists. Turn ignition off. Unplug actuator electrical connectors. Connect Actuator Checker (09990-00150), following manufacturer's instructions.
  2. Start and idle engine. Set actuator checker selector switch to FRONT RH position. Press and hold MOTOR switch for a few seconds. Press and hold brake pedal.
    NOTE: DO NOT press MAIN switch for more than 10 seconds.
  3. Press MAIN switch. When MAIN switch is pressed, brake pedal should not go down. Release MAIN switch. Brake pedal should lower (move down). Press and hold SUB MOTOR switch for a few seconds. Brake pedal should return. Release SUB MOTOR switch. Release brake pedal.
  4. Press and hold SUB MOTOR switch for a few seconds. Release SUB MOTOR switch. Press and hold brake pedal for approximately 15 seconds. While pressing brake pedal, press MOTOR switch for a few seconds. Brake pedal should not pulsate.
  5. Repeat steps 2)
  6. for FRONT LH, and REAR positions of actuator checker selector switch. After checking remaining wheels, press and hold SUB MOTOR switch for a few seconds. Remove actuator checker. Connect actuator wiring to actuator. Clear diagnostic codes. See CLEARING CODES under DIAGNOSIS & TESTING.