LEMON Manuals: Even more car manuals for everyone

ABS ECU Wiring Harness

  1. Remove ABS ECU, leaving connectors attached. See ABS ECU under REMOVAL & INSTALLATION. Backprobe each terminal to measure voltage or continuity at each terminal. If circuit values are not as specified in specification table, check and repair or replace indicated component. See Fig 2.
  2. Disconnect ABS ECU connectors. Measure resistance on wire harness side of ABS ECU connector terminals. If circuit values are not as specified in specification table, check and repair or replace indicated component. See Fig 3.
Fig 1: Identifying ABS Component Connectors
G93D87075Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Testing ABS ECU Wiring Harness - Connected (1 Of 2)
G94D47400Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 3: Testing ABS ECU Wiring Harness - Disconnected (2 Of 2)
G94E47401Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002