LEMON Manuals: Even more car manuals for everyone

Door Lock Control Relay

  1. Disconnect the relay connector. Inspect the connector on the wire harness side, between terminals as shown. See Fig 1 and Fig 2 .
  2. Connect the positive (+) lead from the battery to terminal 3. Connect the negative (-) lead to terminal 4. Check that the solenoid operates in the unlock direction. Then reverse the polarity, and check that the solenoid operates in lock position. If it does not operate, remove and test the solenoid.
  3. If circuit is correct, replace the relay.
Fig 1: Identifying Door Lock Control Relay Connector Terminals
G00112529Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Testing Door Lock Control Relay Continuity
G00112542Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002