Main Switch
- Check for continuity between terminal 3 of main switch and body ground. See Figure. If continuity is present, go to next step. If continuity is not present, check for open between terminal 3 and ground. See WIRING DIAGRAMS .
- Check for battery voltage between terminal 2 of switch and body ground. See Figure. If battery voltage is not present, check for open between main switch terminal 2 and fuse. See WIRING DIAGRAMS . If battery voltage is present, go to next step.
- Check for battery voltage between terminal 6 of harness side of connector and body ground with main switch turned ON. See Figure. If battery voltage is present, go to next step. If battery voltage is not present, check for short circuit in wire between main switch terminal 6 and cruise control computer terminal 10. See WIRING DIAGRAMS . If no short is found, go to step 6).
- Check for battery voltage between main switch terminal 6 and body ground with main switch turned OFF. If battery voltage is present, go to step 6). If battery voltage is not present, go to next step.
- Inspect indicator light operation. Connect main switch terminal 4 to body ground. See Figure. Indicator light should illuminate with main switch turned ON. If indicator light does not illuminate, go to next step. If indicator light does illuminate, check to see if light illuminates with main switch turned OFF. If light illuminates with main switch off, go to next step. If light does not illuminate with main switch turned off, see COMPUTER CIRCUIT below.
- Disconnect main switch. Jumper from positive battery lead to main switch terminal 2, and from negative battery lead to terminal 3. Turn main switch ON and check that there is no continuity between terminals 2 and 6. See Figure. Check that there is no continuity between terminals 2 and 6 with main switch turned OFF. If results are not as specified, replace main switch.