Neutral/Start Switch Circuit
- Turn ignition OFF. Disconnect neutral/start switch connector. Check for continuity between terminal 1 (3S-FE), or terminal 3 (3S-GE) and body ground. See Fig 1. If no continuity is present, check for open between terminal 3 or 1 and body ground. See WIRING DIAGRAMS . If continuity is present, go to next step.
- Check that there is continuity between switch terminals 1 and 2 (3S-FE), or terminals 2 and 3 (3S-FE) with transaxle range selector in "P" or "N" position. If switch does not operate as specified, replace switch. If switch operates properly, reconnect switch connector and go to next step.
- Disconnect computer connector, check for continuity between computer connector terminal 11 and body ground with transaxle range selector in "P" or "N" position. See Figure. If continuity is present, replace cruise control computer. If no continuity is present, check for open between computer connector terminal 11 and switch connector terminal 2. See WIRING DIAGRAMS .
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002