"Cancel" Switch Circuit
- Turn ignition OFF. Disconnect electrical connector from cruise control (SET/COAST, RESUME/ACCEL and CANCEL) switch. Check for continuity between harness side switch connector terminal 17 and body ground. See Figure.
- If no continuity is present, check for open in wire between terminal 17 and body ground, or faulty ground connection. If continuity is present, go to next step.
- Check resistance between switch terminals 5 and 17. See Figure. With switch in "CANCEL" position, resistance should be about 418 Ohms. If resistance is not as specified, replace control switch. If resistance is as specified, go to next step.
- Reconnect control switch connector. Disconnect computer connector. Check resistance value between cruise control computer connector terminal 17 and good body ground with "CANCEL" switch turned on. See Figure. Resistance value should be about 418 ohms. If resistance value is not as specified, check for open or short in White wire between terminal 17 of computer and terminal 5 of control switch. If resistance value is as specified, replace cruise control computer. See WIRING DIAGRAMS .