LEMON Manuals: Even more car manuals for everyone

Drive Plate: Installation

  1. Temporarily install the following parts.
    CAUTION:
    • Install with the stamped mark of the crankshaft position sensor plate facing the transmission side.
    • Align the knock pin hole of the crankshaft position sensor plate to the knock pin of the crankshaft to secure the knock pin.
    • Reinforcement drive plate
    • Drive plate
    • Crankshaft position sensor plate
    • 2.0 L model
      G16342106Courtesy of SUBARU OF AMERICA, INC.
      (A) Crankshaft position sensor plate
      (B) Drive plate
      (C) Reinforcement drive plate
      G16763380Courtesy of SUBARU OF AMERICA, INC.
    • 2.5 L model
      G16342807Courtesy of SUBARU OF AMERICA, INC.
      (A) Crankshaft position sensor plate
      (B) Drive plate
      (C) Reinforcement drive plate
      G16763382Courtesy of SUBARU OF AMERICA, INC.
  2. Set the ST.

    Preparation tool: 

    ST: CRANKSHAFT STOPPER (498497300)

    • 2.0 L model
      G16763383Courtesy of SUBARU OF AMERICA, INC.
    • 2.5 L model
      G16763384Courtesy of SUBARU OF AMERICA, INC.
  3. Tighten the bolts securing the drive plate.
    1. Tighten the drive plate mounting bolts in the numerical order shown in the figure.

      Tightening torque: 

      30 N.m (3.1 kgf-m, 22.1 ft-lb)

    2. Using an angle gauge, tighten the drive plate mounting bolts to the specified angle in the numerical order shown in the figure.

      Tightening angle: 

      30° - 35°

      • 2.0 L model
        Fig 1: Drive Plate Mounting Bolts Tightening Sequence (2.0 L Model)
        G16763385Courtesy of SUBARU OF AMERICA, INC.
      • 2.5 L model
        Fig 2: Drive Plate Mounting Bolts Tightening Sequence (2.5 L Model)
        G16763386Courtesy of SUBARU OF AMERICA, INC.
  4. Install the transmission body. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR580)>TRANSMISSION ASSEMBLY>INSTALLATION .