HVAC System (Heater, Ventilator And A/C): Compressor: Installation
CAUTION:
- After installing the compressor, do not start the engine until the A/C system is charged with refrigerant.
- If the engine is started with no refrigerant charge, replace the compressor assembly.
- Replace the O-rings with new parts, and then apply compressor oil to install completely.
- After replacing the compressor assembly, adjust the amount of the compressor oil. Ref. to AIR CONDITIONER>COMPRESSOR OIL>ADJUSTMENT .
- Install the bracket air conditioner.NOTE: Tighten the bracket air conditioner in the numerical order. Ref. to AIR CONDITIONER>GENERAL DESCRIPTION>COMPONENT>COMPRESSOR .
Tightening torque:
36 N.m (3.7 kgf-m, 26.6 ft-lb)
- Install the compressor assembly.(H4DO model)NOTE: Tighten the compressor assembly in the numerical order as shown in the figure. Ref. to AIR CONDITIONER>GENERAL DESCRIPTION>COMPONENT>COMPRESSOR .
Tightening torque:
36 N.m (3.7 kgf-m, 26.6 ft-lb)
- Install the fuel pipe protector No. 1 and the compressor assembly.(H4DOTC model)NOTE: Tighten the compressor assembly and the fuel pipe protector No. 1 in the numerical order. Ref. to AIR CONDITIONER>GENERAL DESCRIPTION>COMPONENT>COMPRESSOR .
Tightening torque:
25 N.m (2.5 kgf-m, 18.4 ft-lb)
- Install the bracket V-belt cover.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Install the hose pressure suction and the hose pressure discharge.
Tightening torque:
10 N.m (1 kgf-m, 7.4 ft-lb)
- Install the V-belts.
- H4DO model: Ref. to MECHANICAL (H4DO)>V-BELT>INSTALLATION .
- H4DOTC model: Ref. to MECHANICAL (H4DOTC)>V-BELT>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- Charge refrigerant. Ref. to AIR CONDITIONER>REFRIGERANT CHARGING PROCEDURE>PROCEDURE .
- If replacing the compressor assembly with a new part, perform a break-in operation according to the following steps.
CAUTION:
- Do not increase the engine speed to and above 4, 000 r/min unless the break-in operation finishes.
- If the engine may have been started with no refrigerant charge, check for any diagnosis code (DTC) using Subaru Select Monitor. If the code B14A8 (REFRIGERANT NOT SEALED DRIVE ERROR) is output, replace the compressor assembly.
- Check that all connectors are locked securely.
- Reset the air conditioner control module. (Disconnect and then connect the connector)
- Install the delivery mode fuse. Ref. to PRE-DELIVERY INSPECTION>PRE-DELIVERY INSPECTION (PDI) PROCEDURE>DELIVERY MODE .
- Using the Subaru Select Monitor, select the [Variable compressor break-in drive] mode from the work support item list of [Air Conditioner]. Ref. to AIR CONDITIONER (DIAGNOSTICS)>WORK SUPPORT .
- According to the procedure, display [Break-in variable compressor drive, finish status].
- Start and idle the engine at or below 1, 800 r/min. (The compressor operation is automatically changed to the break-in drive mode.)
- When [Break-in variable compressor drive, finish status] changes from [incomplete] to [ON], stop the engine.
- Remove the delivery mode fuse.
- The break-in operation finishes.