LEMON Manuals: Even more car manuals for everyone

Section 12 (Engine Mechanical System (3.6L)): V-belt: Installation

WARNING: This page is about a different variant/trim than selected.
CAUTION:
  • When reusing the V-belt, wipe off dust and water with cloth.
  • Do not use the V-belt if there is any oil, grease or coolant on the belt.
  • Be careful not to rub the belt end surface with bare hands; exposed core may cause injury.
  • Wipe off any dust, oil and water on the groove of each pulley with cloth.
  1. Install the tensioner assembly.

    Tightening torque: 

    20 N.m (2.0 kgf-m, 14.8 ft-lb)

    G12405502Courtesy of SUBARU OF AMERICA, INC.
  2. Make sure that the spline of key (B) on shaft (A) matches with key groove (C), tighten the nut (D) to

    1 N.m (0.1 kgf-m, 0.7 ft-lb), and temporarily assemble the tensioner assembly.

    G13248183Courtesy of SUBARU OF AMERICA, INC.
  3. Install the V-belt (C), and adjust the bolt (B) so as to obtain the specified belt tension. Ref. to MECHANICAL (H6DO)>V-belt>INSPECTION .
    CAUTION: After installing the V-belt, check the V-belt tension and adjust it if necessary by loosening the nuts and tensioner pulley, then reinstall the belt.
  4. Tighten the nut (A).

    Tightening torque: 

    20 N.m (2.0 kgf-m, 14.8 ft-lb)

    G12405501Courtesy of SUBARU OF AMERICA, INC.
    Fig 1: Engine Drive Belt Routing Diagram
    G13248185Courtesy of SUBARU OF AMERICA, INC.
  5. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H6DO)>AIR INTAKE DUCT>INSTALLATION .
  6. Install the collector cover.