LEMON Manuals: Even more car manuals for everyone

Communication For Initializing Impossible

NOTE: If the communication with the body integrated unit is not possible either, refer to LAN SYSTEM (DIAGNOSTICS). Ref. to LAN SYSTEM (DIAGNOSTICS)>SUBARU SELECT MONITOR>COMMUNICATION FOR INITIALIZING IMPOSSIBLE .

Detecting condition: 

Trouble symptom: 

Not communicable with Subaru Select Monitor.

Wiring diagram: 

Power rear gate system Ref. to WIRING SYSTEM>POWER REAR GATE SYSTEM>WIRING DIAGRAM .

G13253653Courtesy of SUBARU OF AMERICA, INC.
  1. CHECK FUSE. 

    Check the fuse.

    Is the check result OK?

    Yes

    Go to  2 .

    No

    Replace the fuse. If the replaced fuse blows out easily, repair the ground short circuit in the harness between the battery and power rear gate control module.

  2. CHECK HARNESS. 
    1. Turn the ignition switch to OFF.
    2. Disconnect the power rear gate control module connectors in the order of (R423) → (R422).
    3. Turn the ignition switch to ON.
    4. Using a tester, measure the voltage between the power rear gate control module connector and chassis ground.

      Connector & terminal 

      (R422) No. 12 (+) - Chassis ground (-):

      (R423) No. 6 (+) - Chassis ground (-):

    Is the voltage 10 - 13 V?

    Yes

    Go to  3 .

    No

    Repair the open circuit of harness between the power rear gate control module connector and fuse.

  3. CHECK HARNESS. 

    Using a tester, measure the resistance between the power rear gate control module connector and chassis ground.

    Connector & terminal 

    (R423) No. 4 - Chassis ground:

    Is the resistance less than 1 Ω?

    Yes

    Go to  4 .

    No

    Repair the open circuit of harness between the power rear gate control module connector and chassis ground.

  4. CHECK BODY INTEGRATED UNIT. 

    Check the body control system. Ref. to BODY CONTROL SYSTEM (DIAGNOSTICS)>BASIC DIAGNOSTIC PROCEDURE .

    Is the check result OK?

    Yes

    Go to  5 .

    No

    Perform the inspection according to the diagnosis for body control system.

  5. CHECK POWER REAR GATE control module. 
    1. Turn the ignition switch to OFF.
    2. Connect the power rear gate control module connector in the order of (R422) → (R423).
    3. Communicate with the power rear gate control module using the Subaru Select Monitor.

    Is communication possible?

    Yes

    The circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

    NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

    No

    Replace the power rear gate control module. Ref. to POWER REAR GATE SYSTEM>POWER REAR GATE control module .