LEMON Manuals: Even more car manuals for everyone

Front Hood: Disassembly

CAUTION:
  • Do not damage the piston rods and oil seals of stay assembly - front hood.
  • Never disassemble the stay assembly - front hood: They contain gas.
  • The hood COMPL - front is heavy. When removing or installing the hood COMPL - front, stay assembly - front hood, and hinge COMPL - front hood, be sure to work in a team of two or more persons.
  1. Remove the clips, and remove the insulator - front hood.
    G10271276
  2. Remove the clips and bolts, and remove the duct - inner front hood.
    • Except for STI model
      G10271277
    • STI model
      G10271278
  3. Release the nuts and clips, then remove the grille - front hood.
    G10271279
  4. Remove the clip, and remove the seal - front duct.
    CAUTION: If the weather strip clip is removed with excessive force, the seal - front duct may be damaged. Be sure to use clip remover, etc. to remove.
    G10271280
  5. Make alignment marks (A), and remove the striker - front hood from the hood COMPL - front.
    G10271281
  6. Remove the stay assembly - front hood from the body.
    1. Float the lock pin using a flat tip screwdriver, etc. and slide it.
    2. Pull the mounting point of the stay assembly - front hood, and remove the stay assembly - front hood.
      G12457265
  7. Remove the hinge COMPL - front hood from the body.
    NOTE: The hinge COMPL - front hood cannot be removed with the fender COMPL - front attached. Therefore, remove the fender COMPL - front beforehand.
    G12457274