Front Wheel Alignment Adjustment
- Adjust the front toe. Ref. to FRONT WHEEL TOE-IN , ADJUSTMENT, Wheel Alignment.
- Check the steering angle of the wheels.
Standard of steering angle:
Inner wheel 38.2°±1.5° Outer wheel 33.6°±1.5° - When the steering wheel is in the following condition, perform the steering wheel installation over again.
- When wheels are set in the straight ahead position, the steering wheel spokes are not horizontal.
- Error is more than 5° on the periphery of the steering wheel.
- If the steering wheel spokes are not horizontal with vehicle set in the straight ahead position after this adjustment, correct it by turning the right and left tie-rods in the opposite direction from each other by the same angle. Also check that there are no abnormal steering effort, failure of the steering wheel to return or other faults.
- Adjust the steering angle sensor. (Models without EyeSight) Ref. to VDC SENSOR MIDPOINT SETTING MODE (MODELS WITHOUT EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Adjust the steering angle sensor. (Models with EyeSight)
- Neutral of Steering Angle Sensor & Lateral G Sensor 0 point setting Ref. to NEUTRAL OF STEERING ANGLE SENSOR & LATERAL G SENSOR 0 POINT SETTING (MODEL WITH EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).
- Longitudinal G sensor & lateral G sensor 0 point setting Ref. to LONGITUDINAL G SENSOR & LATERAL G SENSOR 0 POINT SETTING MODE (MODEL WITH EyeSight) , ADJUSTMENT, VDC Control Module and Hydraulic Control Unit (VDCCM & H/U).