PRG Rod Servicing / One-Time Use Part Information (07-103-15)
Publication date: 2015-12-16Reference number: 07-103-15
PRG ROD SERVICING / ONE-TIME USE PART INFORMATION
TECHNICAL SERVICE BULLETIN
Reference Number(s): 07-103-15, Date of Issue:
December 16, 2015
| SUBARU: | 2015-16 Outback; 2014-16 Forester |
APPLICABILITY
2015-16MY Outback
2014-16MY Forester
Models with Power Rear Gate (PRG)
INTRODUCTION
This Service Information bulletin announces a new requirement regarding one-time use parts which must be replaced whenever disconnecting or replacing the PRG rod. The spring steel retaining clips (Stop Rings) which lock the PRG rod to the ball studs (pivot points) on either end are now one-time use items and must be replaced whenever they are removed. If the stop rings are not replaced, the rod may come off the ball stud during PRG operation.
PART INFORMATION
| DESCRIPTION | PART NUMBER |
|---|---|
| ROD STOP RING | 63369SG000 |
SERVICE PROCEDURE / INFORMATION
- Always follow the applicable Service Manual procedure when replacing any PRG components.
IMPORTANT:
When replacing the stop ring, CAREFULLY
and gradually, apply force to install it onto the ball (pivot) housing. DO NOT
use any excessive force which could deform the part. In the illustration below, the specification for dimension "a" is 6.4 - 7.2mm (.250" - .280"). If dimension "a" exceeds 7.2mm (.280"), the stop ring must be replaced. NEVER
attempt to bend the clip back into specification.
IMPORTANT REMINDERS:
- SOA strongly discourages the printing and/or local storage of service information as previously released information and electronic publications may be updated at any time.
- Always check for any open recalls or campaigns anytime a vehicle is in for servicing.
- Always refer to STIS for the latest service information before performing any repairs.