LEMON Manuals: Even more car manuals for everyone

Headlight Beam Adjustment

WARNING: This page is about a different car, the 2007 Subaru Outback and 2007 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: The headlight can only be adjusted in the vertical direction but not the horizontal direction.
CAUTION: Turn off the light before adjusting the headlight beam level. If it is necessary to inspect the beam level, do not keep the light on for two minutes or more.
NOTE: Before checking the headlight beam level, be sure of the following:
  • Check the area around the headlight for any scratches, damage or other types of deformation.
  • Make sure that the vehicle is parked on a level surface.
  • Make sure that the inflation pressure of tires are correct.
  • Check that the vehicle fuel tank is full.
  1. Bounce the vehicle several times to normalize the suspension.
  2. Make certain that someone is seated in the driver's seat.
  3. Turn the headlights on and then adjust the low beam pattern.
    NOTE: Adjust the headlight beam level by turning the adjusting screw (A).
    Fig 1: Locating Headlight Beam Adjusting Screw
    G05022464Courtesy of SUBARU OF AMERICA, INC.
    Fig 2: Headlight Beam Adjusting Dimension
    G05343965Courtesy of SUBARU OF AMERICA, INC.
HEADLIGHT BEAM REFERENCE CHART

hmm (in) at 3 m (10 ft)
21 (0.83)